Switching to Pollex
Installed and left on your own?
Your devices are fitted, your provider has gone quiet, and nobody is looking after MyGeotab. You're not stuck, and you don't have to start again.
Install
Devices supplied and fitted by installers.
The gap after installConfigure
Set up so the data is right.
Run
Looked after month to month.
Build
What the platform doesn't do.
The usual story
Sound familiar?
Calls to your provider go unanswered. Emails too.
The admin access sits with the old provider. Nobody on your side can add a vehicle or change a rule.
Reports nobody trusts. So nobody uses them, and the system becomes a cost with nothing to show for it.
New vehicles never get set up properly. Each one makes the data a little worse.
Step by step
How switching works
Health check
We review your current set-up and tell you what we find.
Agreed plan
We agree with you what needs fixing and in what order.
Handover
We work with you to get Pollex the access it needs to your MyGeotab database.
Fix
We clean up the set-up so the data can be trusted again.
Ongoing care
If you'd like us to, we run MyGeotab for you from then on.
Afterwards
What changes after you switch
You have someone to call, a set-up that makes sense, and reports you can use.
Configuration
We fix what the health check found, for a fixed fee agreed up front.
MyGeotab as a service
We look after the system each month, so it stays right.
Free data health check
Start with a free health check
The health check is the first step. It shows the state of your current set-up before anything changes. You get a two to three page written report on your top five problems, then a 30-minute call. It's free, and it's not a sales pitch.